Superior Liquid Cooling Systems®English v1.00ERM-3K3UUser’s ManualERM-3K3UUser’s Manualwww.koolance.comISO 9001Printed in Korea
1213User ManualInstallationExternal Nozzles & CablesPlug the external 9-pin cable into the cooling system. This plug carries the temperature senso
1415User ManualInstallationInstall the Slot Adapter into any available rear card slot in your computer.Screw the Slot Adapter in place as you would a
1617User ManualInstallationATX Pass-Through LeadThe ATX pass-through lead is responsible for sending the shut-down signal if any sensor reaches the pr
1819User ManualParallel LoopsParallel loops are normally used to help accommodate water blocks with significantly disproportionate flow restriction. T
2021User ManualContinue connecting all of your coolers in the system until there are no longer any open tubing ends.With the connected outlet hose, ro
2223User ManualSlowly fill the system. To maintain the product warranty, use only Koolance approved coolant. Many alternative liquids and additives ca
2425User ManualFilling & MaintenanceWith normal use, Koolance’s liquid coolant should be replaced every 2-3 years. If it ever becomes contaminated
2627User Manualthis procedure may not be possible since there will be no visible air gap.5. My computer has boot-up problems, or does not turn on...Th
28Limited WarrantyDisclaimerKoolance Incorporated (“Koolance”) warrants each new Koolance liquid-cooled system (“the system”), against defects in mate
iUser ManualThis User Manual is updated regularly. Please be sure to check our support page for a newer version of this guide: www.koolance.com/suppor
iiiiiUser ManualTable of ContentsSystem Features 1System Diagram ...
iv1User Manual - External Power Cable - Slot Adapter (includes temperature sensors and ATX lead) - Rubber foot pads - ATX power jumper wire - Use
23User ManualERM-3K3U System DiagramReservoirRadiator(Primary Heat Exchanger)Radiator - The primary heat exchanger is the main cooling element, and pr
45User ManualCAUTION: Generally, sensors report liquid temperature at the water block, which is typically 5-10°C (9-18°F) lower than the actual heat s
67User Manual System FeaturesPUMP SETThe pump speed can be manually set from 1-10: PUMP(1-10) 7LV : Pump Speed LevelThe pump speed level wil
89User Manual System FeaturesThis page is intentionally left blank.The selected line will flash. Use ▼ and ▲ to navigate to other lines. Press ◙ to
1011User ManualPositioning the ERMThe ERM-2K3U is designed to operate in 3 different orientations. The display can be rotated by gently pulling forwar
Kommentare zu diesen Handbüchern